10
Receiver to TV, VCR and Decoder with SCART Cables
DECODER
DECODER SCART
1. Connect the Off-air TV antenna or cable if available to the ANT IN socket of the EchoStar AD-3000IP VIACCESS.
2. Connect the TV OUT socket of the EchoStar AD-3000IP VIACCESS to the RF IN of the VCR.
3. Connect the RF OUT of the VCR to the RF IN of the TV set.
4. Search on the VCR for UHF channel # 38. This is the default channel where the EchoStar AD-3000IP VIACCESS is
programmed to.
5. Connect the SCART cable from the TV SCART of the EchoStar AD-3000IP VIACCESS to the TV SCART from the TV
set.
6. Connect the SCART cable from the VCR SCART of the EchoStar AD-3000IP VIACCESS to the SCART of the VCR.
7. Connect the SCART cable from the DECODER SCART of the EchoStar AD-3000IP VIACCESS to the SCART of the
DECODER.
Note : Use different UHF channels for VCR and EchoStar AD-3000IP VIACCESS.
TV SCART RF IN
RF OUT RF IN VCR SCART
TV ANTENNA
VCR
TV
To Next Page
Loading...
