Section 3
Installation
Page 3 - 4 EchoStar DSB-707 Viaccess
© 2001 EchoStar International Corporation
All rights reserved
FOR FIXED AND DISEQC 1..4 SWITCH INSTALLATIONS
NOTE
The receiver needs the correct local time to collect and show the EPG (Electronic
Program Guide). An incorrectly entered local time will result in no EPG information.
15. Make the required selections.
16. Read the available help text for information;
Note that the local time is shown correctly.
17. Go to the Continue field.
18. On the RCU, press the OK key to advance.
NOTE
From the next step onwards, the procedure is divided into different configurations.
The configurations are; Fixed, DiSEqC 1.2 and SMATV.
■ Fixed means set up a single dish or multiple dishes with DiSEqC1..4 switch;
■ DiSEqC 1.2 means set up a moveable dish according the DiSEqC 1.2 spec;
■ SMATV means set up for television distribution (cable network in buildings).
19. Make the required selections.
20. Read the available help text for information.
Note that only the white fields are selectable,
other fields show reference information.
21. Go to the Check Signal field.
22. On the RCU, press the OK key to advance.
23. Wait for the Checking Configuration to complete.
24. Make the required selections.
25. Read the available help text for information.
26. If the red dot in the transponder field stays:
a. select another transponder;
b. go to the check signal field;
c. on the RCU, press the OK key.
27. Go to the Search Channels field.
28. On the RCU, press the OK key to advance.
To Next Page
Loading...
