Ecler CA120 - Page 48

48
XOVER_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Shows the current CROSSOVER FILTER status (ON or OFF) for the
specified output zone
XOVER_TYPE
<Zone=ZA:ZD>
LP/HP
Shows the current CROSSOVER FILTER TYPE (LP or HP) for the
specified output zone
XOVER_FREQUENCY
<Zone=ZA:ZD>
<Frequency=Hz>
Shows the current CROSSOVER FILTER FREQUENCY (Hz) for the
specified output zone
TYPE
PARAM1
PARAM2
PARAM3
PARAM4
DESCRIPCIÓN
INC/DE
C
PRESET_NUMBER
<Count>
INCrements / DECrements the current active PRESET number
IN_VOL
<Input=I1:I5>
<Count>
Increments / decrements a certain INPUT’s current VOLUME. The increment
applied is defined by the Count parameter (dBx10)
IN_BASS
<Input=I1:I5>
<Count>
Increments / decrements a certain INPUT’s current BASS tone LEVEL. The
increment applied is defined by the Count parameter (dBx10)
IN_MID
<Input=I1:I5>
<Count>
Increments / decrements a certain INPUT’s current MIDDLE tone LEVEL. The
increment applied is defined by the Count parameter (dBx10)
IN_TREBLE
<Input=I1:I5>
<Count>
Increments / decrements a certain INPUT’s current TREBLE tone LEVEL. The
increment applied is defined by the Count parameter (dBx10)
XLEVEL
<Input=I1:I5>
<Zone=ZA:ZD>
<Count>
Increments / decrements a certain CROSSPOINT current VOLUME (matrix level
sent from one input to one output). The increment applied is defined by the
Count parameter (dBx10)
ZONE_VOL
<Zone=ZA:ZD>
<Count>
Increments / decrements a certain output ZONE current VOLUME. The increment
applied is defined by the Count parameter (dBx10)
GEQ_GAIN
<Zone=ZA:ZD>
<Band=B1:B10>
<Count>
Increments / decrements, in a certain output ZONE, the current GAIN for a certain
GRAPHICAL EQUALIZER band. The increment applied is defined by the Count
parameter (dBx10)
TYPE
PARAM1
PARAM2
PARAM3
PARAM4
DESCRIPCIÓN
ERROR
<Error ID>
“<Error Description>”
Informs about an error
ERROR CODES