Ecler CA120 - Page 61

61
XOVER_TYPE
<Zone=ZA:ZD>
LP/HP
Shows the current CROSSOVER FILTER TYPE (LP or HP) for the
specified output zone
XOVER_FREQUENCY
<Zone=ZA:ZD>
<Frequency=Hz>
Shows the current CROSSOVER FILTER FREQUENCY (Hz) for the
specified output zone
COMPRESSOR_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Shows the current COMPRESSOR status (ON or OFF) for the specified
output zone
COMPRESSOR_THRESHO
LD
<Zone=ZA:ZD>
<Threshold=dBx10>
Shows the current COMPRESSOR THRESHOLD LEVEL (dBx10) for
the specified output zone
COMPRESSOR_RATIO
<Zone=ZA:ZD>
<Ratio=x100>
Shows the current COMPRESSOR RATIO (x100) for the specified
output zone
COMPRESSOR_ATTACK
<Zone=ZA:ZD>
<AttackTime=msx10>
Shows the current COMPRESSOR ATTACK TIME (milliseconds x10)
for the specified output zone
COMPRESSOR_RELEASE
<Zone=ZA:ZD>
<ReleaseTime=msx10>
Shows the current COMPRESSOR RELEASE TIME (milliseconds x10)
for the specified output zone
COMPRESSOR_KNEE
<Zone=ZA:ZD>
SOFT/HARD
Shows the current COMPRESSOR KNEE mode (SOFT or HARD) for
the specified output zone
COMPRESSOR_GAIN
<Zone=ZA:ZD>
<Gain=dBx10>
Shows the current COMPRESSOR GAIN (dBx10) for the specified
output zone
DELAY_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Shows the current DELAY status (ON or OFF) for the specified output
zone
DELAY_TIME
<Zone=ZA:ZD>
<DelayTime=msx10>
Shows the current DELAY TIME (milliseconds x10) for the specified
output zone