Ecler eMOTUS5P - POSITIONING AND FITTING; Mounting and Placement Guidelines

6
 LED activity display
 Reinforced ABS construction
 BT wireless connection, remote control port (0-10 VDC – RJ45 connector) and
remote control (eMOTUS5PB)
 Available in black and white
6. POSITIONING AND FITTING
In the packing of the eMOTUS systems, you will find all you need to complete
installation of the two units.
The following should be observed as general rules:
 Always install on solid, firm surfaces.
 For good sound reproduction, there should be no hindrance between the units and
the audience.
 Adjust the levels of sound pressure to reproduction requirements. Despite its small
size, the eMOTUS5P / eMOTUS5PB has a performance far higher than that of
domestic loudspeakers.
Procedure for installing on a surface:
1. Make three 6 mm screw holes in the wall, aligned with the position of the holes
in the bracket.
2. Insert three 6 mm wall plugs into the holes.
3. Fasten the safety line on the rear of the bracket.