40
8.2. Function diagram
8.2. Diagrama de funciones
8.2. Schéma de fonctions
8.2. Funktionsübersicht
CH I ATT
CH II ATT
BRIDGED SIGNAL CLIP PROTECT THERMAL
CH I
CH II
POWER
0 10
2
3
4
5
8
7
6
9 9
6
7
8
5
4
3
2
100
0 10
2
3
4
5
8
7
6
99
6
7
8
5
4
3
2
100
POWER
CH II
CH I
THERMALPROTECTCLIPSIGNALBRIDGED
CH II ATTCH I ATT
CH I ATT
CH II ATT
SIGNAL CLIP PROTECT THERMAL
CH I
CH II
POWER
0 10
2
3
4
5
8
7
6
9 9
6
7
8
5
4
3
2
100
SWITCHING POWER MOSFET AMPLIFIER SIGNAL OUTPUTS
CHANNEL II CHANNEL I
MAINS INPUT
SIGNAL INPUTS
CHANNEL I
CAUTION:
WARNING:
CHANNEL II
CAUTION: FLOATING OUTPUTS, DO NOT GROUND
EARTH LINK
GND
ON OFF
CHANNEL II CHANNEL I
T 16A 6,3x32
REPLACE ONLY WITH SPECIFIED FUSE.
THIS APPARATUS MUST BE EARTH.
STACKING OUTPUT INPUT
STACKING OUTPUT INPUT
PIN 1 - GROUND
PIN 2 - PHASE
PIN 3 - NON PHASE
MAINS INPUT
WARNING:
SA 10A 6,3x32
REPLACE ONLY WITH
SPECIFIED FUSE.
THIS APPARATUS
MUST BE EARTHED.
OFFON
EARTH LINK
GROUND
PIN 3 - NON PHASE
CHANNEL I (BRIDGE INPUT)CHANNEL II
STACKING OUTPUT INPUTSTACKING OUTPUT INPUT
STEREO BRIDGED
OP. MODE
SIGNAL INPUTS
PIN 2 - PHASE
PIN 1 - GROUND
PIN 3 - NON PHASE
PIN 2 - PHASE
PIN 1 - GROUND
SIGNAL INPUTS
OP. MODE
BRIDGEDSTEREO
INPUTSTACKING OUTPUT INPUTSTACKING OUTPUT
CHANNEL II CHANNEL I (BRIDGE INPUT)
1 3 4 5 6 7
765431 2
21 3 4 5 6 7
9 10 11 12 13
14 15 16
811
17 1310 9 1214
11
17 9 8
FUSE FUSE
FUSE
FUSE
SWITCHING POWER MOSFET AMPLIFIER
SIGNAL OUTPUTS
CHANNEL II BRIDGED CHANNEL I
CHI-II
1+LIVE
1-GND
BRIDGED
1+LIVE+
1-LIVE-
IMPORTANT: MINIMUM NOMINAL LOAD IMPEDANCE
MUST BE 4 OHM FOR STEREO AND
8 OHM FOR BRIDGE OPERATION.
SWITCHING POWER MOSFET AMPLIFIER
SIGNAL OUTPUTS
BRIDGED CHANNEL ICHANNEL II
1-LIVE-
1+LIVE+
BRIDGED
1-GND
1+LIVE
CHI-II
IMPORTANT: MINIMUM NOMINAL LOAD IMPEDANCE
MUST BE 4 OHM FOR STEREO AND
8 OHM FOR BRIDGE OPERATION.
MAINS INPUT
SA 16A 6,3x32
ON
OFF
EARTH LINK
CAUTION: REPLACE ONLY WITH SPECIFIED FUSE.
WARNING: THIS APPARATUS MUST BE EARTHED.
GND
To Next Page
Loading...
