How to operate the CD player
11
IV
How to operate the CD player
About compact discs
• The signal recorded on a compact disc is read by a laser beam, so nothing touches the disc surface.
A scratch on the recorded surface or a badly warped disc may cause deteriorated sound quality or
intermittent playback. Observe the following precautions to ensure high quality sound performance:
About brand new CDs
• Do not leave an ejected disc in the disc slot for very long; the disc may
warp. Discs should be stored in their cases and kept away from high
temperature and humidity.
• Do not stick a piece of paper or tape on the disc. Do not write on or
scratch either side of a disc.
• Discs spin at a high speed inside the deck. Keep cracked or warped
discs out of the player to avoid damage to the deck.
• Avoid touching the recorded surface when handling a disc; handle
discs by their edges.
• You may notice that some brand new discs are rough around the
center hole or outside edge. Remove the rough edges with the side of
a ballpoint pen, etc. Rough edges may prevent proper loading in the
deck. Flakes from the rough edges may also stick to the recorded
surface and interfere with playback.
Rough Edges
Rough Edges
Recorded surface
Ballpoint pen
Flakes
III
To Next Page
Loading...
Need help?
General
