How to operate the tuner
17
V
How to operate the tuner
ATTENTION
If stations have been stored in memory,
pressing a button from [1] to [6] will directly
select a station. (Refer to "Manually setting
stations into memory" on page 18.)
Tuning to a station
Radio bands will switch from FM1 ➔
FM2 ➔ FM3 ➔ AM in order each time
the button is pressed.
[]
button:
Starts searching toward higher
frequencies.
[] button:
Starts searching toward lower
frequencies.
ATTENTION
At times, it may be difficult to maintain optimum
reception because the antenna affixed to your
vehicle is in motion constantly (relative to the
broadcast antenna), encountering continuous
variation in the received radio signals’ strength.
Other factors affecting reception include
interference from natural obstacles, sign posts,
etc.
Entering stations into memory
automatically
(The automatic preset mode:
ASM)
ASM is available for the FM radio mode.
You can switch the mode to desired
one.
The automatic preset mode starts.
[ASM ON] will appear on the display,
and stations are automatically entered
in memory under the buttons [1] to [6].
These buttons are called preset
buttons.
CAUTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in the memory
again.
1
Press the [BAND] button to switch
to the desired FM, AM bands.
2
Press the [ ] or [ ] button to
start the automatic station search.
● MEMO ●
To tune to a station manually;
Press the [ ] or [ ] button until “M” is
displayed. When “M” is displayed,
press the [ ] or [ ] button to select a
station you want to listen to.
1
Press the [BAND] button.
2
Press the [FUNC] button.
3
Press the [3] button for several
seconds while [FUNC] is blinking.
IV
To Next Page
Loading...
Need help?
General
