Eclipse CD3000 User Manual

36
Various Settings
How to operate the AUDIO CONTROL
Switching audio control modes
Various audio control modes may be fine-tuned using this procedure.
Modes will switch in the order shown below each time the button is pressed.
VOL ➔ BASS ➔ MID ➔ TREB ➔ BAL ➔ FAD ➔ NON-F*
1
➔ SVC*
2
➔ LOUD
➔ VOL www
*1: NON-F (non-fader) Output is not affected by the settings of the BASS, MID,
TREBLE, loudness function or equalizer.
*2: Setting cannot be made in FM mode.
ATTENTION
Press the [MUTE] button for less than one second to cut the volume or restore it instantly.
1
Press the [AUDIO CONTROL] button for less than one second to select the item
to be adjusted.
WARNING
Do not adjust the volume or other controls while driving the vehicle. Do so only while parked in a
safe location.
Mode Function
[AUDIO CONTROL] button
Turn to the Left Turn to the Right
VOL (VOLUME) Adjusts volume.
Decreases the
volume.
Increases the
volume.
BASS
Adjusts bass level. Bass mode can be
adjusted for each source
(CDP/CDC, FM ,AM).
Softens low sounds.
Emphasizes low
sounds.
MID (MIDDLE)
Adjusts middle level. Mid mode can be
adjusted for each source
(CDP/CDC, FM , AM).
Softens medium
sounds.
Emphasizes medium
sounds.
TREB (TREBLE)
Adjusts treble level. Treble mode can be
adjusted for each source
(CDP/CDC, FM , AM).
Softens high sounds.
Emphasizes high
sounds.
BAL (BALANCE)
Adjusts left/right speaker balance.
Emphasizes left
speakers.
Emphasizes right
speakers.
FAD (FADER) Adjusts front/rear speaker balance.
Emphasizes rear
speakers.
Emphasizes front
speakers.
NON-F (NON-FADER)
Adjusts non-fader level (for connected
sub-woofers, etc.).
Decreases level. Increases level.

Eclipse CD3000 Specifications

General

Brand	Eclipse
Model	CD3000
Category	Car Receiver
Language	English