How to operate the Sound Adjustment Mode
41
X
Making changes with Sound Adjustment Mode
Enters sound adjustment mode.
When the button is turned, the setting item changes in the following order.
Press the [SEL] button to select the setting item. After selecting the setting item, follow
the procedures in the list below.
At this time, other adjustments can also be made in sound adjustment mode.
1
Press the [SOUND] button more than one second.
2
Turn the [SEL] button to select a setting item.
Crossover adjustment (X-Over F/R)
The HPF (high-pass filter) for front and rear speakers can be switched ON and OFF.
Turn the [SEL] button to select ON or OFF.
Press the [SEL] button.
ATTENTION: The set value of the HPF is 100 Hz, 18 db/oct.
Crossover adjustment (X-Over NF)
The LPF (low-pass filter) for sub-woofer can be switched ON and OFF.
Turn the [SEL] button to select ON or OFF.
Press the [SEL] button.
ATTENTION: The set value of the LPF is 80 Hz, 18 db/oct.
Non-Fader phase selection (Non-F Phase)
The merging of sound between the front and rear speakers and the woofer can be improved by selecting the
phase. Switch to a phase which lets the speakers combine without any disharmony.
Turn the [SEL] button to select the NORMAL or REVERSE.
NORMAL: Normal phase
REVERSE: Reverse phase
Press the [SEL] button.
3
Press the [RTN] button.
4
Press the [SOUND] or [RTN] button to exit sound adjustment mode.
1
2
1
2
1
2
To Next Page
Loading...
Need help?
General
