Eclipse TFB, V2, Installation Guide 310, 11/14/2014
16
This chapter is divided into two sections:
• Maintenance procedures
• Troubleshooting guide
Maintenance
Preventive maintenance is the key to a reliable, safe and
efficient system. The core of any preventive maintenance
system is a list of periodic tasks.
The following are suggestions for a monthly list and a
yearly list.
NOTE: The monthly list and yearly lists are an average
interval. If the environment is dirty, the intervals may be
shorter.
Monthly Checklist
1. Inspect flame sensing devices for good conditions,
and cleanliness.
2. Check for proper inlet air/gas ratios.
3. Test all the alarm systems for proper signals.
4. Check spark rod for damage or distortion.
5. Check valve motors and control valves for free,
smooth action and adjustment.
6. Measure and record the high fire oxygen levels in the
exhaust every month. If there is any change, find the
cause and correct it.
7. View down the peepsights on the burners and down
the exhaust legs of the tubes to check for unusual
flame or carbon build-up. If necessary, remove the
burner to investigate.
Yearly Checklist
1. Test interlock sequence of all safety equipment.
Manually make each interlock fail, noting that related
equipment closes or stops as specified by the
manufacturer.
2. Test (leak test) safety shut-off valves for tightness of
closure.
3. Test main fuel hand valves for operation.
4. Test pressure switch settings by checking switch
movements against pressure settings and comparing
with actual impulse pressure.
5. Visually check ignition cable and connectors.
6. Inspect impulse piping for leaks.
7. Remove and inspect all the burners. Clean off any
carbon build up.
8. Make sure that the following components are not
damaged or distorted.
• The burner nozzle
• The spark rods
• The flame tube
If applicable, remove and clean all the orifice plates.
Maintenance &
Troubleshooting
5
To Next Page
Loading...
Need help?
General
