ECM Giotto - Page 5

User’s manual Giotto 5
To ensure maximum performance efficiency,it is esssential to follow the manufacturer’s
instructions concerning routine preventative maintenance and servicing. This must only be carried
out by ECM authorised technicians.
It is the responsability of the user to notify the manufacturer of any defects or damages which may
affect the safety of the original installation or future safe operation of the machine.
The user must respect the safety regulations at the point of installation.
The user must check the surrounding area to ensure safe and hygenic use are guaranteed.
The machine component’s manufacturers are responsible for the parts supplied by them. The
customer is responsible for the personal use of the equipment.
It is the responsibility of the user ensure that the location of the machine is hygienic, and that its
continued safe operation can be guaranteed.
When the machine is not being used for long periods of time, the hydraulic systems should be
drained completely and the machine stored in a temperature above freezing (0°C or 32°F).
This will prevent the hydraulic system from freezing which could damage internal pipes and boiler.
All spare parts fitted to the machine must be original ECM components.
All maintenance must be carried out exclusively by ECM authorized technicians.
Before any cleaning or undertaking internal maintenance the machine should be disconnected from
the electric supply.
Never pull the electrical supply cable.
When cleaning the machine never use caustic or abrasive cleaning chemicals.
To avoid electric shocks:
e Ensure that the machine is installed with a proper Earth/ground in accordance to local safety
practises, codes and legislation.
e Prevent the power cable from being stretched, or pulled tight.
Avoid using the machine with wet hands.
e Never operate the machine in bare feet.
Never operate the machine without ensuring the tank contains water.
The machine must be operated with clean water. If the local water supply has a high mineral content
use water softeners. A build up of mineral deposit may restrict the flow of water within the
hydraulic systems causing damage to the machine and risking personal injury.
The machine must only be operated with drinking water.
The machine must be switched off whenever it is left unattended.