E C O P H Y S I C S Operating Guide
CLD 780 TR / July 2000 58
5.2.2.7 Calibration of the CLD 780 TR and PLC 762
Depending on the measurement mode selected in window (3), the user
will be prompted to perform a calibration of the CLD 780 TR or of the PLC
762.
– If one of the following is selected under “Measurement Mode“:
– “NO“
– “NO.c“
– “NO and NO.c“
window (30) appears and the operator will be offered the option of
performing a calibration with NO and/or zero air. See also 5.2.2.7.1.
– If “NO and NO
2
“ is selected under “Measurement Mode“, window
(41) appears and the user is asked if the analyzer or the PLC 762
converter is to be calibrated (5.2.2.7.2). Depending on the answer the
appropriate calibration procedure is initiated.
– If one of the following is selected under “Measurement Mode“:
– “NO (cont.)“
– “NO.c (cont.)“
window (51) appears and the operator will be offered the option of
performing a calibration with NO and/or zero air. See also 5.2.2.7.1.
Note: The calibration procedure can be interrupted anytime in any win-
dow by pushing the “MEAS“ key. This will return the operator to the
measurement window (1) or (1a).
To Next Page
Loading...