Ecodyne Water Systems IDP40S

To Next Page

7371046 (Rev. A 6/5/18)

Designed, Engineered &

Assembled in the U.S.A.

Manufactured by

Ecodyne Water Systems

1890 Woodlane Drive

Woodbury, MN 55125

OWNER’S MANUAL

How to install, operate

and maintain your

Models

IDP30S Water Softener

IDP40S Water Softener

IDP40CC

Chloramine

& Chlorine Water Conditioner

IDP50CC

Chloramine

& Chlorine Water Conditioner

Models IDP30S & IDP40S tested and certified by

NSF International against NSF/ANSI Standard 44

for hardness reduction and efficiency and the

reduction of barium and radium 226/228,

and certified to NSF/ANSI Standard 372.

Models IDP30S & IDP40S tested and certified by

the Water Quality Association against CSA B483.1.

Ù Models IDP40CC & IDP50CC have not been

tested or certified by NSF International or the

Water Quality Association.

Main Page

Need help?

Do you have a question about the Ecodyne Water Systems IDP40S and is the answer not in the manual?

Summary

Safety Guides

Specifications

Before Starting Installation

WHERE TO INSTALL THE SOFTENER

Guides on selecting an appropriate location for the water softener.

TOOLS, PIPE & FITTINGS, OTHER MATERIALS YOU WILL NEED

Lists necessary tools and materials for installation.

Typical Installation Illustrations

INSTALLATION USING SINGLE BYPASS VALVE

Illustrates the setup using a single bypass valve system.

INSTALLATION USING 3-VALVE BYPASS

Illustrates the setup using a 3-valve bypass system.

Installation Steps

TURN OFF WATER SUPPLY

Instructions to shut off the water supply before installation.

INSTALL BYPASS VALVE AND;OR PLASTIC ADAPTORS

Steps for installing the bypass valve or plastic adaptors.

Installation Details

INSTALL VALVE DRAIN HOSE

Steps for connecting the drain hose to a suitable drain point.

BRINE TANK ASSEMBLY

Instructions for assembling the brine tank components.

Final Installation Steps

CONNECT BRINE TUBING

Instructions for connecting the brine tubing to the valve.

PRESSURE TESTING AND INITIALIZATION

Steps for leak testing, programming, and initial rinse.

Installation & Sanitizing

Sanitizing the Water Softener

Procedure for sanitizing the water softener unit.

Setup Procedure

CURRENT TIME

Setting the current time for accurate operation.

Programming the Water Softener

Controller Menu Options

Lockout Feature

Salt Settings

Setting Salt Level

Recharge and Time Programming

Recharging the Softener

Setting the Current Time

Basic Setting Adjustments

Setting Recharge Time

Setting Water Hardness and Iron Level

Cycle Time Adjustments

Special Feature Configuration

Efficiency Mode

Diagnostics and Setup Management

Diagnostics

Setup Changes

Routine Maintenance Procedures

Adding Salt

Breaking a Salt Bridge

Component Cleaning and Maintenance

Cleaning the Nozzle & Venturi

Troubleshooting Guide

Common Problems and Initial Checks

Automatic Diagnostics and Turbine Checks

Automatic Electronic Diagnostics and Error Removal

Manual Diagnostics and Turbine Checks

Advanced Troubleshooting and Service

Manual Advance Recharge Check

Other Service Issues

Valve Position Indicators