ECT Install and User Guide
Feb 2023
7 of 61
ECOER INC.
Manufacturer reserves the right to change specifications or designs without notice.
3.4 Battery installation
NOTE : Put on a flat surface. Be careful not to distort the back
plate of the wire controller by overtightening the mounting screws.
• Put the battery into the installationsite and make sure the positive
s
ide of the battery is in accordance with the positive side of
installationsite. (See Fig.3-5)
• Please set the time corrected on the first time operation. Batteries
in the wire controller can time under power failure which ensure
the time keep right. When the power restores, if the time
displayed is not correct, it means the battery is dead and replace
the battery.
Fig 3-5
To Next Page
Loading...
