ECOFOREST Eco I Insert - 3.12.1. POWER MODE.; 3.12.2 TEMPERATURE MODE.

41
Drawing 13
LEVEL
1 - 9
Power level in T mode. See section 5.6.
SENSOR
SONDA / THERMOST.
Select zone control terminal.
SCHEDULE
OFF / ON
Enable or disable calendar programming.
STANDBY.
MIN / OFF
Activate work at minimum or on / off by zone control terminal.
dTON
0 - 5
ΔTOFF differential.
For a finer adjustment of this mode, please check point 5.5.
3.12.1. POWER MODE.
The regulation range goes from level 1 to level 9 (minimum to maximum pellet drop.) To increase the level
we’ll use the upwards arrow (
) while the downwards arrow will be used to decrease ().
Drawing 14
3.12.2. TEMPERATURE MODE.
When choosing the temperature working mode, the P will turn into a T. We should choose this mode, only if
the room probe or a tension free thermostat with its adapter is connected.
The regulation with room probe ranges from 12°C to 40°C, being the latter the highest regulating temperature.
To increase the temperature we’ll push the up arrow (
) and the down arrow will be used to decrease ().
Drawing 15
PROBE:
THERMOSTAT:
Drawing 16