3
1. Description 3
2. DISPLAY LAYOUT 4
3. MODES 5
3.1 Power On 5
3.2 Standby 5
3.3 Run Mode 6
3.3.1 Single Booster with high and low pressure 6
3.4 Power O 7
3.5 Error Mode 7
4. CONTENT OF MAIN- AND SUBMENUS 8
5. OVERVIEW OF MAIN- AND SUB-MENUS 9
5.1 Content of the Info menu 10
5.2 Content of the Errors menu – CAUSE & REMEDY 11
5.2.1 Error List 11
5.3 Content of the Setup sub menu Settings 13
5.4 Content of Setup menu 14
5.4.1 Submenu Language & Units 16
5.4.2 Submenu Supply tank 16
5.4.3 Submenu Communication 17
5.4.4 Submenu Settings 17
5.4.5 Submenu Installation 17
5.4.6 Submenu Reset 17
5.5 Content of Readings 18
6. UPGRADE FIRMWARE 19
6.1 Upgrade display using USB Cable 19
6.2 Upgrade display using IrDA Cable 21
6.3 Upgrade Inverter 23
To Next Page
Loading...
Need help?
General