Nexa™ Customer Service Reference Guide January 2014 Page 11
CONFIDENTIAL
12. Replacement Push Bar (For Manual Dispensers)
a. To install a replacement push bar, you must first remove the existing push bar.
To do this, remove the cover from the dispenser by pinching the hinges together.
b. Then pull on one side of the dispenser to remove one side of the push bar rod
from its hole.
c. The push bar will then fall out easily.
d. To insert the new push bar or the elbow activator, stick one side of the push bar /
elbow activator rod into the appropriate hole and pry the cover open so the other
side of the rod can be seated.
To Next Page
Loading...