Ecofoot2Plus_Install_Guide_V1.6-FINAL Page 4 of 12
January 5, 2018, ES10560 ecolibriumsolar.com
Disclaimer of Liability
ECOLIBRIUM SOLAR® does not assume responsibility and expressly disclaims liability for loss, damage, or
expense arising out of, or in any way connected with installation, operation, use, or maintenance by using this
manual.
ECOLIBRIUM SOLAR assumes no responsibility for any infringement of patents or other rights of third
parties, which may result from use of modules. No license is granted by implication or under any patent or
patent rights. The information in this manual is believed to be reliable, but does not constitute an expressed
and/or implied warranty.
ECOLIBRIUM SOLAR reserves the right to make changes to the product, specifications, data sheets and this
manual without prior notice. This document is not prescriptive regarding safety and does not purport to
address all the safety concerns that may arise with its use. Contractors should become familiar with all
applicable safety, health, and regulatory requirements before beginning work.
Unauthorized field modification of ECOLIBRIUM SOLAR components or assemblies may affect
ECOLIBRIUM SOLAR warranty coverage. Provide written drawings for ECOLIBRIUM SOLAR’s review,
comment and approval prior to attempting any field modifications.
Warnings & Safety
Both electrical and roofing knowledge are required to correctly and safely install a solar photovoltaic system. Only
qualified and certified installation professionals should install EcoFoot2+. Failure to follow the methods and
procedures outlined in this guide may result in injury and/or damage to property.
Carefully read this guide before starting any work. Store a copy of this guide on the job site at all times and contact
Ecolibrium Solar with any installation questions related to EcoFoot2+.
Please note the following warnings when installing EcoFoot2+:
• EcoFoot2+ components fit together tightly and could cause pinch injuries.
• EcoFoot2+ components may be hot to the touch if left in the sun.
Please follow the safety requirements below when installing EcoFoot2+:
• Always keep children and unauthorized people away from work areas.
• Always wear required OSHA approved Personal Protective Equipment (PPE).
• Always use insulated tools when working with or near electrical systems.
• Always provide OSHA approved fall protection for all installation personnel.
• Never wear jewelry during mechanical and electrical installation work.
• Never work in rain, snow or extremely windy conditions.
• Never leave a module unsupported or unsecured on the roof.
• Never install broken photovoltaic modules.
• Never use photovoltaic modules as a work surface.
EcoFoot2+ General Application Notes
Site-Specific System Design: Ecolibrium Solar provides drafting services on all EcoFoot2+ projects. This service
produces a site-specific design package with an Engineered Stamped Layout including detailed ballast
plan and bill of materials.
Roof Type: EcoFoot2+ is designed to mount photovoltaic modules to a range of roof surfaces, including: EPDM, TPO,
PVC, Mineral Cap Sheet (a.k.a. Rolled Asphalt), Tar and Gravel.
To Next Page
Loading...