Ecolink PIR-ZWAVE2 User Manual

© 2015 Ecolink Intelligent Technology Inc. PN PIR-ZWAVE2 R1.04
Motion Sensor with Pet Immunity Installation Instructions
Product Overview
 Z-Wave Plus
TM
enabled device which transmits upon detection of movement
 Configurable to be less sensitive to the movement of small and medium size household pets
 Reports tamper condition if cover is removed
Product Specifications
 For indoor use only
 Operating frequency: 908.42 MHz
 Operating range: Up to 100 feet (30.5 meters) line-of-sight
 Operating temperature: 0˚C to 49˚C, 32˚F to 120˚F (ambient temperature)
 Detection radius: Maximum 45 feet (see detection region diagram)
 Detection angle: 45 degrees in either direction from the sensor’s center (see detection region diagram)
 Battery type: 3V Lithium CR123A
 Battery life: approximately 3 years
 Passive Infrared (PIR) based technology
Network Inclusion
The sensor must be added to a Z-Wave network prior to use. To include the sensor in a network, both the sensor and the network controller must
be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the
controller’s inclusion mode.
STEP ONE Start by placing the controller into inclusion mode.
STEP TWO Activate inclusion mode for the sensor by removing the battery isolation pull tab, or by inserting the battery (see next
section for battery installation tips). When the inclusion process is complete the red LED will turn on for approximately 10
seconds and then it will go out. If the LED continues to flash repeat the inclusion process.

Ecolink PIR-ZWAVE2 Specifications

General

Communication Protocol	Z-Wave
Power Source	Battery
Battery Type	CR123A Lithium Battery
Operating Frequency	908.42 MHz
Detection Range	up to 30 feet
Mounting	Wall or Ceiling
Tamper Protection	Yes
Field of View	110 degrees
Type	Motion Sensor
Weight	4.5 ounces
Certifications	Z-Wave Certified

Summary

Network Inclusion Process

Device Installation

Mount Bracket to Wall

Attach the sensor mounting bracket to the wall using adhesive tape or screws, at 6.5-7.5 feet height.

Attach Detector to Bracket

Align the motion detector with the bracket and slide down until it snaps tight to secure it.

Adjust Motion Sensor Sensitivity

Sensor Test Mode

Enter test mode by connecting the 'TEST' pins to shorten sensor reset time for easier motion detection testing.

Understanding Z-Wave Technology

Z-Wave Device & Command Classes

Details Z-Wave sensor's generic and specific device classes and supported command classes for integration.

Sensor Awake & Configuration

Association Groups Explained

Explains the two association groups for controlling devices and receiving important motion and tampering notifications.

Network-Wide Inclusion

Describes how the sensor can be included into a Z-Wave network over the mesh network, not just near the controller.

Sensor Configuration Options

Configuration Parameter Values

FCC Compliance

Product Warranty Information