www.ecosmartre.com
ENGLISH
e-NRG Bioethanol is the only fuel to use in this appliance.
Clearances & Installation
Top Tray
The incorporation of a Top Tray into your setting protects against heat
transference and aids in the collection of accidental spillage. Some
models come with Top Trays, others do not. Top Trays are available as
an accessory through The Fire Company or your local distributor.
The Fire Company Pty Ltd is not liable for any injuries or damages
sustained through the use of Top Trays not manufactured by The
Fire Company Pty Ltd;
When installing multiple Burners a maximum of three [3] Burners may
be installed into the one Top Tray (excluding the XL Series which can
only have one [1] Burner per Top Tray). Special considerations should
be made to multiple Burner installations in order to avoid potential
accidents. Contact your local distributor about design and analysis
advice to minimise adverse impacts.
Top Trays provided by The Fire Company are tted directly into the
Burner shelf from above. The Burner is then inserted into the Top Tray
setting and adjusted (using the levelling screws) to sit ush.
The size of the cut-out should not give more than 5mm [0.196in]
clearance. Top Trays must not be more than 200% of the total size
of the corresponding Burner.
For cut out dimensions for your model please contact your local
distributor.
Physical model dimensions should be veried against cut out
dimensions BEFORE installation begins to conrm tolerances align.
To Next Page
Loading...