6.2 Specifications of Power Supply .
Fig.6-1
6.1 Electrical Wiring Illustration
pavE :3T orator Temp. Sensor
rosneS .pme T tneibmA :4T
)reppu( rosneS .pme T kna T :U5T
TP: Discharge Temp. Sensor
Earthing
)rewol( rosneS .pme T kna T :L5T
TH: Suction Temp. Sensor
WARNING
The unit must be installed with an RCD
near
the
power
supply ylevitcef f e eb tsum dna
earthed.
Please choose the power cord according to above table, and
make sure it comply with local electric standard.
Recommended power cord mode is H05RN-F.
CAUTION
The power supply should be hard wired.
Power supply circuit should be earthed e
ively.
The wiring must be performed by professional technicians in
accordance with national wiring regulations and the circuit
diagram below.
An all-pole disconnection device which has at least 3mm
separation distance in all pole and a residual current device
(RCD)with the rating of above 10mA shall be incorporated in
the
xed wiring according to the national rule.
Set the electric leakage protector according to the relevant
AS/NZS electric al standards.
The power cord and the signal cord shall be laid out neatly
and properly without mutual interference or contact the
connection pipe or valve.
After wire connection, check it again and make sure of
connection before power is turned on.
elba T . 6-1
4
/ 04 30
A m 03
≤
c e s 1 . 0
RSJ-35/300RD N3
4
5 UT
5 LT
T P
6. ELECTRICAL CONNECTION
To Next Page
Loading...