ECOVACS Deebot N8 Pro+ - Debris in Dust Container.; DEEBOT leaks dust or debris.; Base is dirty.; Wi-Fi Connection

23
EN
No. Malfunction Possible Causes Solutions
14
DEEBOT fails to auto-empty
the Dust Bin.
The Auto-Empty Dust Bin is not installed.
Please install the Auto-Empty Dust Bin with two Auto-
Empty Outlets on the bottom.
The Dust Bag is full. Replace the Dust Bag and close the Dust Container Lid.
The Auto-Empty Outlets on the Auto-Empty
Dust Bin is stuck by debris.
Uninstall the Auto-Empty Dust Bin and clean the debris
on the Auto-Empty Outlets.
Dust Evacuation Tube is blocked. Clean the Dust Evacuation Tube.
15
There is debris in the Dust
Container.
Fine particles are absorbed inside the Dust
Container through the Dust Bag.
Clean the Dust Container Lid and inner wall.
The Dust Bag is damaged. Check the Dust Bag and replace it.
16
DEEBOT leaks dust or debris
while cleaning.
The Auto-Empty Outlets are stuck by debris. Uninstall the Auto-Empty Dust Bin and clear the debris.
17 The Base is dirty.
Main Brush has debris on it and requires cleaning. Clean the Main Brush.
Wi-Fi Connection
Before Wi-Fi setup, make sure DEEBOT, mobile phone, and Wi-Fi network meet the following requirements.
DEEBOT and Mobile Phone Requirements
• DEEBOT is fully charged and the power switch of DEEBOT is turned on.
• Wi-Fi status light slowly ashes.
• Turn off mobile phone’s cellular data (you can turn it back on after setup).
Wi-Fi Network Requirements
• You are using a 2.4GHz or 2.4/5 GHz mixed network.
• Your router supports 802.11b/g/n and IPv4 protocol.
• Do not use a VPN (Virtual Private Network) or Proxy Server.
• Do not use a hidden network.
• WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.
• WEP EAP (Enterprise Authentication Protocol) is not supported.
• Use Wi-Fi channels 1-11 in North America and channels 1-13 outside North America (refer to local regulatory agency).
• If you are using a network extender/repeater, the network name (SSID) and password are the same as your primary network.