If Cycle Mode selected, the icon will display.
In Cycle mode, when the memory is full, the oldest data sets
stored will be overwritten by the new ones entered.
If Acyclic Mode selected, the icon will display
In Acyclic Mode, when the memory is full, logging stops.
Logging will continue when memory is cleared via the PC
You can set max. 4 time periods through the setting menu on
the PC software. These periods can’t be overlapped. The time
period must be later than the current time. It will start logging
from the set start time and stop from the set end time in a time
Time period 1
Time period 2
Time period 3
Time period 4
If time period was selected, the time period icon circle frame
To Next Page
Loading...