ECOWITT DS-102 - Device Configuration and Modes; Device Modes

7
4. Program Mode
There are six program modes: Quick Display Mode, Setting
Mode, Max/Min mode, Sleep Mode, Calibration mode and Data
Logging mode.
4.1 Quick Display Mode
In Normal Mode, press the “SET” button to enter the Quick
Display Mode as follows
1) Display time
2) Display date
3) Logging interval
4.2 Setting Mode
In Normal Mode, press the “SET” button for 2 seconds to enter
Set Mode. The first setting will begin flashing. You can press
the “SET” button again to skip any step, as defined below.
1) 12/24 hour format
2) Manual time setting (hour/minutes)
3) Date setting(DD-MM/MM-DD)
4) Calendar setting (year/month/date)
5) Temperature display unit degree Celsius or Fahrenheit
6) Logging interval setting from 8 seconds to 4 hours (default
5minute)
The temperature and humidity data will be measured per
60 seconds as default and be stored according to the
logging interval. If the interval is set to a number less than
60 seconds, both the temperature and humidity data will
be measured and stored according to the logging interval
time.