ECS 945GCT-D - Standard CMOS Setup

26
Using BIOS
Standard CMOS Setup
This option displays basic information about your system.
Date Mon 01/01/2007
Primary IDE Master Not Detected
Primary IDE Slave Not Detected
SATA1 Not Detected
SATA2 Not Detected
Help Item
CMOS Setup Utility -- Copyright (C) 1985-2005, American Megatrends, Inc.
Time 00 : 03 : 36
While entering setup,
BIOS auto detects the
presence of SATA
devices. This displays
the status of auto
detection of SATA
devices.
IDE BusMaster Enabled
Standard CMOS Setup
Date & Time
The Date and Time items show the current date and time on the computer. If you are
running a Windows OS, these items are automatically updated whenever you make
changes to the Windows Date and Time Properties utility.
Primary IDE Master/Slave; SATA1/2
f
Your computer has one IDE channel which can be installed with one or two devices
(Master and Slave). In addition, this motherboard supports two SATA channels and
each channel allows one SATA device to be installed. Use these items to configure
each device on the IDE channel.
CMOS SETUP UTILITY -- Copyright (C) 1985-2005, American Megatrends, Inc.
Secondary IDE Master
Secondary IDE Master
Type Auto
LBA/Large Mode Auto
Block (Multi-Sector Transfer Auto
PIO Mode Auto
DMA Mode Auto
S.M.A.R.T Auto
32Bit Data Transfer Enabled
Help Item
Select the type
of device connected
to the system.
Device : Not Detected
f
f
f
f
mnlk
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Optimized Defaults
F1: General Help
mnlk
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Optimized Defaults
F1: General Help