28
Using BIOS
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Advanced Setup
This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Advanced Setup
Thermal Management Enabled
TM Status TM1/TM2
Limit CPUID MaxVal Disabled
Intel XD Bit Enabled
Hyper-Threading Technology Enabled
Quick Power on Self Test Enabled
Boot up Numlock Status On
APIC Mode Enabled
1st Boot Device Hard Disk
2nd Boot Device CD/DVD
3rd Boot Device Removable Dev.
Hard Disk Drives Press Enter
Boot Other Device Yes
Help Item
For the processor its CPUID
belows 0F41h. TM2 only can
be enable under below setting.
1. Freq.>=3.6GHz FSB800
2. Freq.>=2.8GHz FSB 533
Limit CPUID MaxVal (Disabled)
Use this item to enable or disable the Max CPU ID value limit.
Intel XD Bit (Enabled)
This item enables or disables the Intel XD Bit technology.
Hyper-Threading Technology (Enabled)
This item is only available when the chipset supports Hyper-Threading and you are
using a Hyper-Threading CPU.
mnlk
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Optimized Defaults
F1: General Help
APIC Mode (Enabled)
This item allows you to enable or disable the APCI (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
f
Thermal Management (Enabled)
This item displays CPU’s temperature and enables you to set a safe temperature to
Prescott CPU.
TM Status (TM1/TM2)
This item displays CPU Monitor status.
To Next Page
Loading...
