Chapter 2
8
A68M-C4DL USER MANUAL
The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.
1. To avoid the system instability after clearing CMOS, we recommend users to
enter the main BIOS setting page to “Load Default Settings” and then “Save
and Exit Setup”.
2. Make sure the power supply provides enough VCC_DUAL voltage before
selecting the VCC_DUAL function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto 2-3 pin
rather than 1-2 pin as default if you want to wake up the computer by USB/
PS2 KB/Mouse.
2-3. Checking Jumper Settings
To Next Page
Loading...
