KeyBoard Power On Function
If you enable this item, you can turn the system on and off by pressing hot
keys on the keyboard. You must enable the Keyboard Power On jumper and
use an ATX power supply in order to use this feature.
PCI / Plug and Play Setup
This page sets some of the parameters for devices installed on the PCI bus
and devices that use the system plug and play capability.
AMIBIOS SETUP – PCI / PLUG AND PLAY SETUP
(C) 2000 American Megatrends, Inc. All Rights Reserved
Plug and Play Aware O/S Yes
AGP 4X Control Enabled
Primary Graphics Adapter AGP
Allocate IRQ to PCI VGA Yes
PCI IDE BusMaster Disabled
ESC : Quit ↑↓←→ : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift)F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
Plug and Play Aware O/S
Enable this item if you are using an O/S that supports Plug and Play such as
Windows 95/98/ME.
AGP 4X Control
This item enables or disables the AGP 4X function.
Primary Graphics Adapter
This item indicates if the primary graphics adapter uses the PCI or the AGP
bus. The default PCI setting still lets the onboard display work and allows the
use of a second display card installed in a PCI slot.
Allocate IRQ to PCI VGA
If this item is enabled, an IRQ will be assigned to the PCI VGA graphics sys-
tem. You set this value to No to free up an IRQ.
PCI IDE BusMaster
This item enables or disables the DMA under DOS mode. We recommend you
to leave this item at the default value.
30
To Next Page
Loading...
