F
F
e
e
a
a
t
t
u
u
r
r
e
e
s
s
Processor
• Supports AMD Athlon XP/Athlon/Duron processors
• Supports 266 MHz Front-Side Bus
Note: Processors are automatically configured using
firmware and a synchronous Host/DRAM Clock
Scheme.
Memory
• Two 168-pin DIMM slots for SDRAM memory modules
• Two 184-pin DIMM slots for DDR memory modules
• Support SDRAM up to 133 MHz and DDR up to 266 MHz
memory bus
• Maximum installed memory is 1GB
Note: You cannot use SDRAM and DDR simultane-
ously.
Expansion Slots
• One AMR slot for a special audio/modem riser card
• One AGP slot for AGP 2.0-compliant interface (supports
1.5V AGP card only)
• Five 32-bit PCI slots for PCI 2.2-compliant bus interface
Note: The PCI1 slot does not concurrently work with
USB 2.0 controller (VT6202). Therefore, you
must disable the USB 2.0 controller through
BIOS setup before using the PCI1 slot.
Onboard IDE
channels
• Primary and Secondary PCI IDE channels
• Support for PIO (programmable input/output) modes
• Support for Multiword DMA modes
• Support for Bus Mastering and Ultra DMA 33/66/100
modes
Power
Supply and
Power
Management
• ATX power supply connector
• Meets ACPI 1.0b and APM 1.2 requirements, keyboard
power on/off
• Supports RTC Alarm, Wake On Modem, AC97 Wake-Up
and USB Wake-Up
Audio
• Compliant with AC’97 2.2 specification
• Full-duplex Codec with independent and variable sam-
pling rate
• Earphone Buffer Built-In, SNR up to 90db
• 2Ch DAC, support 2-channel speak-out
• Advanced power management support
Built-in Ethernet
LAN (optional)
• Built-in 10BaseT/100BaseTX Ethernet LAN
• LAN controller integrates Fast Ethernet MAC and PHY
compliant with IEEE802.3u 100BASE-TX, 10BASE-T and
ANSI X3.263 TP-PMD standards
• Compliant with ACPI 1.0 and the Network Device Class
Power Management 1.0
• High Performance provided by 100Mbps clock generator
and data recovery circuit for 100Mbps receiver
2
To Next Page
Loading...
