Floppy Drive
Swap
If you have two diskette drives installed and you
enable this item, drive A becomes drive B and drive
B becomes drive A.
Floppy Drive
Seek
If you enable this item, your system will check all
floppy disk drives at start up. Disable this item
unless you are using an old 360KB drive.
Password Check
If you have entered a password for the system, use
this item to determine if the password is required to
enter the Setup Utility (Setup) or required both at
start-up and to enter the Setup Utility (Always).
Boot to OS/2 >
64MB
Enable this item if you are booting the OS/2
operating system and you have more than 64MB of
system memory installed.
L1/L2 Cache
Leave these items enabled since all the processors
that can be installed on this board have internal
cache memory.
System BIOS
Cacheable
If you enable this item, a segment of the system
BIOS will be cached to main memory for faster
execution.
Timing Setting
Mode
Use this item to determine the timing setting mode
of the memory. We recommend that you leave this
item at the default value.
SDR/DDR CAS
Latency
This item determines the operation of the SDRAM
/DDR memory CAS (column address strobe). We
recommend that you leave this item at the default
value. The 2T setting requires faster memory that
specifically supports this mode.
Auto Detect
DIMM/PCI Clk
Use this item to enable the DIMMs or PCI slots to
detect automatically device then generating clock.
Clk Gen Spread
Spectrum
Use this item to enable the clock to generate spread
spectrum.
To Next Page
Loading...
