ECS P965T-A - Chapter 5 JMicron RAID Setup Guide; JMicron RAID Configuration Overview; Creating a RAID Set

53
JMB361 RAID Setup Guide
Chapter 5
JMB361 RAID Setup Guide
JMicron
®
RAID Configuration
The JMicron
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and JBOD sets
on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk
3. Microsoft
®
Windows
®
OS installation disk (Windows 2000/XP)
4. Motherboard support CD with JMB361 driver
Complete the following steps before you create a RAID set:
1. Install the external Serial ATA hard disk drives (HDDs) on your system.
2. Set the SATA2 Controller item in the BIOS to .RAID Mode..
See section “ Onboard Device ” for details.
3. Enter the JMB361 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB361 RAID driver disk for Windows
®
OS installation. See section
“Creating a RAID driver disk” for details.
5. Install the JMB361 driver after the Windows
®
OS had been installed.
USB Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Enabled]
USB Mouse Support [Enabled]
RTL GLAN Device [Enabled]
Onboard lan boot ro [Enabled]
Azalia codec [Enabled]
SATA2 Controller [RAID Mode]
Phoenix-AwardBIOS CMOS Setup Utility
Onboard Device
Item Help
ff
Menu Level
mnlk
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help