ECS P965T-A - Rebuilding a Mirror Drive; Saving RAID Settings and Exiting

60
JMB361 RAID Setup Guide
Saving the settings and exiting setup
When you have finished, highlight Save & Exit Setup using the up/down arrow key then
press <Enter> to save the current RAID configuration and exit the JMB361 RAID BOS
utility.
A dialogue box appears to confirm the action. Press <Y> to confirm; otherwise, press <N>
to return to the JMB RAID BIOS menu.
To rebuild a Mirror drive:
1 In the main JMB361 RAID BIOS menu, highlight Rebuild Mirror Drive using the
up/down arrow key then press <Enter>.
2. Using the <TAB>, move to the RAID Disk Drive List menu and highlight the RAID
set that you want to rebuild. Press <Del> to begin rebuilding the Mirror con-
figuration.
A status bar at the bottom of the screen shows the progress of the rebuilding.
Rebuilding a Mirror Drive
When one of the disks in a RAID 1 (Mirror) configuration is unplugged from the system,
then plugged in again, a dialogue box appears to ask you to rebuild the Mirror drive.
Press<Y>toconfirm;otherwise, press<N>. Press <Y> to confirm; otherwise, press <N>.
This option allows you to rebuild the Mirror drive later and synchronize the data between
two hard disks.