M3 Vital Signs Monitor Service Manual
- 25 -
3.4 Connect Sensor to Patient
Connect all the necessary patient sensors between the monitor and the patient.
NOTE:
For information on correct connection, refer to related chapters in User manual.
3.5 Check the Recorder
If your monitor is equipped with a recorder, open the recorder door to check if paper is properly
installed in the slot. If no paper present, refer to User manual for details.
3.6 Other Notes
l When the monitor is used with other electrical medical equipment, it should comply with the
relative regulations to protect against burns to the patient and medical staff.
l EXPLOSION HAZARD-Do not use the device in a flammable atmosphere where
concentrations of flammable anesthetics or other materials may occur.
To Next Page
Loading...
