Chapter 24
| Multicast Filtering Commands
MVR for IPv4
– 743 –
show mvr members This command shows information about the current number of entries in the
forwarding database, detailed information about a specific multicast address, the IP
address of the hosts subscribing to all active multicast groups, or the multicast
groups associated with each port.
Syntax
show mvr [domain domain-id] members [ip-address |
host-ip-address [interface] | igmp | sort-by-port [interface] | unknown |
user]]]
domain-id - An independent multicast domain. (Range: 1-5)
ip-address - IPv4 address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
members - The multicast groups assigned to the MVR VLAN.
host-ip-address - The subscriber IP addresses.
igmp - Entry created by IGMP protocol.
sort-by-port - The multicast groups associated with an interface.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
unknown - Entry created by receiving a multicast stream.
user - Snooping entry learned from user’s configuration settings.
Default Setting
Displays configuration settings for all domains and all forwarding entries.
Command Mode
Privileged Exec
Example
The following shows information about the number of multicast forwarding entries
currently active in domain 1:
Console#show mvr domain 1 members
MVR Domain : 1
MVR Forwarding Entry Count :1
Flag: S - Source port, R - Receiver port.
H - Host counts (number of hosts joined to group on this port).
P - Port counts (number of ports joined to group).
Up time: Group elapsed time (d:h:m:s).
Expire : Group remaining time (m:s).
To Next Page
Loading...
Need help?
General