Edge-Core ECS4620-28F-2AC - Table 4: Configuration Command Modes

Chapter 2 | Using the Command Line Interface
Entering Commands
– 103 –
◆ VLAN Configuration - Includes the command to create VLAN groups.
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to “Console(config)#” which
gives you access privilege to all Global Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
Table 4: Configuration Command Modes
Mode Command Prompt Page
Access Control
List
access-list arp
access-list ip standard
access-list ip extended
access-list ipv6 standard
access-list ipv6 extended
access-list mac
Console(config-arp-acl)
Console(config-std-acl)
Console(config-ext-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-mac-acl)
417
396
396
403
403
410
CFM ethernet cfm domain Console(config-ether-cfm) 825
Class Map class-map Console(config-cmap) 646
ERPS erps domain Console(config-erps) 556
DHCP ip dhcp pool Console(config-dhcp) 893
Interface interface {ethernet port | port-channel id |
vlan id}
Console(config-if ) 424
Line line {console | vty} Console(config-line) 155
MSTP spanning-tree mst-configuration Console(config-mstp) 529
Policy Map policy-map Console(config-pmap) 650
Router router {bgp | ipv6 ospf | ospf | pim | pim6 |
rip}
Console(config-router) 1085
1046
1003
1184
1207
985
Time Range time-range Console(config-time-range) 189
VLAN vlan database Console(config-vlan) 591