Edge Tub - Recommended Routine Maintenance

09
Recommended Routine
Maintenance
To ensure the longevity of your Edge Tub, it is recommended to perform maintenance on your Chiller and Tub on a regular basis. This maintenance protocol will help ensure that
the Chiller functions as expected and that the water quality of the Tub is kept clean and clear. The steps below detail out the recommended maintenance, which should be
performed every three months.
Tub
Chiller
Disconnect the Tub from the Chiller.
Drain all water from the Tub and Chiller Hoses.
Using mild soap and water, wash down the inside and outside of the Tub
using a washcloth or soft sponge. Place the Chiller Hoses inside the Tub and
run soapy water through them.
Rinse Tub and Chiller Hoses off with clean water.
Allow Tub and Chiller Hoses to air dry completely; preferably in direct
sunlight.
Any marks or scuffs on the Tub can be removed by lightly scrubbing with a
moistened Magic Eraser. Do not scrub aggressively or it may damage the
material, and do not use on any logos or printed areas.
Check air pressure of the Tub by connecting the Double Action Air Pump and
refilling to 10 PSI.
Check the area where the Tub was located for any signs of mildew buildup
and clean if necessary. If large amounts of mildew buildup are noticed, the
Tub may need to be placed on a material that can breathe to allow water to
evaporate.
Refill with water and perform Initial Sanitizer protocol to sanitize the new
water.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Disconnect the Chiller Hoses from the Tub. Ensure Tub Valve Fittings are in the
closed (perpendicular) position if the Tub still contains water.
Place both ends of the Chiller Hoses into a 5 gallon bucket or similar container. Fill
with distilled white vinegar (cleaning vinegar) and water at a 1:4 ratio. So for a 5
gallon bucket, fill 1 gallon vinegar, and 4 gallons water, being careful to leave room
for water to circulate and not overflow.
Turn on the Chiller and run in heating mode at 104ºF. Allow the Chiller to circulate
water for 30 minutes.
Turn off the Chiller and empty the bucket of water. Refill with clean water. Place
Chiller Hoses back in the bucket and run the Chiller for another 30 minutes. The
descaling process is now complete.
With a soft cloth, wipe down the exterior of the Chiller with mild soap and water.
Wipe off all soap residue with damp cloth.
With Chiller Off, inspect fan and remove any debris that may be on or around the
fan shroud.
Descaling
1.
2.
3.
4.
Housing Maintenance
1.
2.
3.
25