The Threaded Collar on the Valve Fitting
should be screwed onto the Tub Fitting
by rotating it clockwise until hand
tight. Do not tighten with tools. The
Valve Fittings should be oriented as
shown
(see image).
Remove the Chiller and Tub from their
shipping cartons, and remove protective
wrapping. We recommend keeping the
Chiller box for future transportation
needs. When choosing your location,
select a flat and smooth surface that is
free from objects that could potentially
puncture or damage the bottom of the
Tub. A water source and 120v power
source should be accessible. We
recommend setting the tub up in a
sheltered area if being set up outdoors
for an extended period of time for
longevity of your product. Remove the
Tub from the Carrying Backpack, then
remove the Storage Strap and set aside. If
using the optional Protection Mat, first
place the mat down in the desired
location. Unfold the Tub in the desired
orientation.
Setup
DETAILED SETUP VIDEOS CAN BE FOUND HERE.
Inflate the Tub using the included
Double Action Air Pump, ensuring that
the Inflation Hose is connected to the
“Inflate” side of the pump (see image a).
Open the Inflation Valve Cap on the Tub
by rotating counterclockwise. When
inflating the Tub, check to ensure that
the Inflation Valve Pin is in the
depressed (out) position or the air will
be released after the Inflation Hose is
detached (see image The Inflation Hose
connects to the Inflation Valve with a
quarter turn clockwise to attach. Inflate
until the gauge reads 10 PSI. Do not
over inflate or product damage will
occur. When done inflating, replace the
Inflation Valve Cap with a clockwise turn.
Step 1 – Unbox your Chiller
and Tub
Step 2 – Install the Valve
Fittings to the Tub
04
Setup Instructions
Step 3 – Inflalte the Tub
(see image a).
(see image b).
12
To Next Page
Loading...