13
Operating Instructions
Control Panel Overview
Press this button once to manually turn the unit on. Press this button once
more to turn the unit off.
In COOL mode, press “-” once, and the set temperature will decrease by
1° Fahrenheit. Continue to press this button until you reach your desired
temperature. Press “+” to increase the temperature by 1° Fahrenheit until
you reach your desired temperature.
Press the MODE button repeatedly to cycle between modes: Cooling, Dry,
and Fan Only mode. The indicator light corresponding to each mode will
illuminate when that mode is selected.
The exhaust hose and window kit must be installed when the unit is in Cool
or Dry mode. It is unnecessary to have these items connected when the
unit is in Fan Only mode.
When the unit is running in Cool or Fan mode, press the Fan speed button
to select your desired fan speed. There are four fan speeds: High,
Medium, Low, and Auto.
When the unit is running in Cool or Dry mode condensation will drain to the
water reservoir. When the water tank is full a buzzer will sound eight (8)
times to indicate that the reservoir needs to be emptied. The error code
“H8” will also display on the LED screen. Follow the draining instructions
on page 11.
This unit has 4-way directional louvers. Use the louver guides to direct air
where cooling or fan output is desired. Hold the louver and adjust the air
flow direction as shown in the diagram on the following page.
To Next Page
Loading...
