Installing the Batteries
1. Remove the cover on the back of the remote control.
2. Insert the batteries with the (+) and (-) ends pointing in the direction indicated.
3. Install the cover on the back of the remote control.
Cooling Mode
Cooling mode cools and dehumidifies the air. If the ambient temperature drops below the
temperature you selected, the compressor turns off and the unit functions with the fan only. When
the temperature rises above the temperature you selected, the compressor turns on again.
Whether your desired temperature can actually be reached depends on the ambient conditions.
The room temperature remaining above the set temperature is normal.
To operate the unit in cooling mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button on the remote.
3. Press the Mode button until the Mode Indicator Light on the Control Panel turns blue.
4. Select the fan speed by using the Speed button.
5. Set the thermostat by using the Up and Down buttons. The thermostat is adjustable between
61°F - 86°F in one degree increments.
Fan Only Mode
Fan Only mode is used to circulate the air in your room. No temperature setting is needed.
To operate the unit in Fan Only mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button on the remote.
3. Press the Mode button until the Mode indicator light turns green.
4. Press the Speed button to select the fan speed. You can choose between High, Medium and
Low. The LED indicator next to the speed will light up.
Caution: Use only AAA batteries. Remove the batteries if the remote control will not be used for
one month or longer. Do not attempt to recharge batteries that are not designed to be recharged.
All batteries should be replaced at the same time. Do not mix old and new batteries. Do not
To Next Page
Loading...
