EdgeStar AP13500G - Installation of the Exhaust Hose

12
7. Install Sash Seal
• Cut the foam seal to an appropriate length.
• Insert the foam seal between the top of the inner window and the outer window to create a
proper seal.
Installation of the Exhaust Hose
1. Assemble Window Exhaust Adapter
• Connect the two pieces of the Window Exhaust Adapter.
• Press each side together and firmly snap the clasps into the corresponding slots.
2. Attach Exhaust Hose to Window Exhaust Adapter
• Press the round end of the Window Exhaust Adapter against the end of the Exhaust Hose.
• Rotate the hose counterclockwise into the round end of the Window Exhaust Adapter until
it is firmly attached.
Note: The sash seal is thicker than the window panel seal and does not include an adhesive
backing.