EdgeStar AP13500G - Remote Control

19
Remote Control
The included universal remote control is used to operate all of your portable air conditioner’s
functions. Use the remote control to change modes, fan speed, timer, and temperature settings.
Installing the Batteries
1. Remove the battery cover plate on the rear of the remote control by sliding it out.
2. Remove and properly dispose of old batteries.
3. Insert two(2) new AAA 1.5 batteries.
4. Reinstall the battery cover plate.
Button
Function
On / Off
This button powers the unit on or off.
Mode
This button allows you to cycle through the
following modes: Cool, Dry, and Fan.
+
This button increases the set temperature, or
the time when the Timer is enabled.
-
This button decreases the set temperature, or
the time when the Timer is enabled.
Fan
This button allows you to adjust the fan speed.
X-Fan
This button enables the X-Fan mode.
Temp
This button is used to display the set
temperature or the current temperature.
Timer On /
Timer Off
This button is used to turn the Timer function
on or off.
Turbo
This button enables the Turbo Mode or turns it
off.
Sleep
This button enables the Sleep Mode or turns it
off.
Light
This button turns the unit’s light on or off.
Note: Be careful not to drop the remote control. Do not place the remote control in a location
exposed to direct sunlight.
Caution: Use only AAA batteries. Remove the batteries if the remote control will not be used for
one month or longer. Do not attempt to recharge batteries that are not designed to be recharged.
All batteries should be replaced at the same time. Do not mix old and new batteries. Do not
dispose of batteries in a fire as they may explode.