EdgeStar BR1000SS - Refrigerator Fan Motor Circuit

25
10.3 Refrigerator fan motor circuit
 The fan motor runs with the compressor.
 Check if there is 12V voltage between FAN pin and GND during normal operation.
 There should be 6V or more between FAN pins.
 If there is no voltage detected when the compressor is running, replace the fan motor or main
PCB with a new one.
 Also adjust the multi meter to test for DC voltage.
 Put the black probe on the GND pin and put the red probe on the FAN pin when the motor is
running.
 There should be 6V or more detected.
 When the fan motor is shutdown the detected voltage should be 0V.