EasyManuals Logo

EdgeStar DEP701WP User Manual

EdgeStar DEP701WP
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
6
LED Display
There are 2 LED displays located on the control panel of this unit.
Temperature and Timer Display
When
operating
normally,
this
will display the current
temperature
in
the
room where the
dehumidifier is
located.
When adjusting the timer
setting,
this will display the hours
remaining
for the
timer.
Humidity Level Display
When
operating
normally,
this
will display the current relative humidity
in
the room where the
dehumidifier is
located.
When adjusting the
desired
humidity setting, this will display the
humidity level you set
.
Error Codes
In
addition
to showing the
humidity, the
display screens may show
the
following error
codes:
E1
-Temperature
sensor
error
E2
-
Defrost
sensor
error
E3- Humidity
sensor
error
For
El, E2, and
E3
error codes, power the unit off, and then unplug the
unit
for
15
minutes.
Plug the unit in and power i t on. If the
issue persists, please
contact
customer service.
LO
-
Temperature too low error
This means the current room
temperature
is
below
32°F.
Make sure the
ambient
temperature
is
suitable for the unit (4
1
°F
-
95°F). If
the
ambient
temperature
is
suitable,
please contact
customer
service.
HI-
Temperature too high
error
This means the current room
temperature
is
above
122°F. Make sure the
ambient
temperature
is
suitable for the unit (4
1
°F
-
95°F). If
the
ambient
temperature
is
suitable,
please contact
customer
service.
Water Full Light
The Water Full Light will illuminate when the bucket is ready to be emptied. The light also turns
on when the bucket is not installed at all or is not installed correctly. Once the water is drained,
and the bucket is properly installed, the light will no longer illuminate and the unit will operate
normally.
Additional Notes About the Dehumidifier’s Behavior
Once the unit reaches the desired humidity level, the power
button
will remain lit while the
compressor and fan shut
off.
When turning the unit off and
back
on in a normal manner
the
dehumidifier will retain
its
last target humidity settings
except
In
the
event of
a
power interruption (i.e. power
outage
or if unit is
unplugged).
If the unit
is
turned on when the room's relative humidity
is
lower
than
the desired humidity
level, the unit will run for a short period of
time
and then the compressor and fan will shut
off.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EdgeStar DEP701WP and is the answer not in the manual?

EdgeStar DEP701WP Specifications

General IconGeneral
BrandEdgeStar
ModelDEP701WP
CategoryDehumidifier
LanguageEnglish

Related product manuals