8
Manual Drain
The
dehumidifier
can
be
drained
manually using the water
bucket. When
the bucket
is
full,
the
unit will
automaticall
y
stop running, and the
Bucket
Full
light will illuminate. Follow the below
steps to remove the
bucket
and
dump the
water.
1. Slowly and carefully pull the bucket out by the handles and
lift
upward
to
remove it.
2.
Use
both hands to carefully empty the water
bucket.
3.
Reinstall the
bucket.
Please
note that this unit
is
designed to
not
operate
if the water
bucket
has not been installed
properly.
Additional notes when emptying the water bucket:
• Do not place the bucket on the floor as its bottom is uneven and it will not stand upright on its
own.
• There is a carrying handle located inside the water bucket that can be used as needed for
carrying the water bucket.
Continuous Gravity Drain
The
dehumidifier
can
be
drained
continuously to a suitable floor drain
by
using the gravity drain
port. In order to utilize the continuous gravity
drain
you will need to supply
a
suitable drain hose.
You may use a
standard
garden
hose with a
3
/
4
"
connector fitting.
1. Locate the gravity drain hose port found on the
back
of the
unit
(located
on the
middle, right
hand side).
2. Unscrew the drain cover by turning it counter clockwise, and
remove
the rubber
stopper.
3. Screw the drain hose onto the
threaded
portion of the drain
outlet
and
tighten it
firmly.
4. Place the other end of the drain hose in a floor drain or
other
suitable
drainage
port. The drain must be
located
below the
level
of
the drain outlet on the
back
of the unit to allow for proper
gravity
drainage.
Warning: The water produced by the dehumidifier is not potable or suitable for drinking. Do not
drink the water drained from the unit as it contains contaminates that could make you sick.
Note: A continuous gravity drain hose is not included. It must be provided separately. A
dehumidifier drain hose or standard garden hose with a
3
/
4
" fitting is required. As with all hose
attachments, ensure that a rubber gasket is installed in the hose fitting in order to prevent leaks.