Why doesn't water feed into my EdgeStar IB120SS Ice Maker after starting?
If water isn't feeding into your EdgeStar Ice Maker after it starts, ensure the water supply tap is turned on. If it is on, check that the water supply pipe is properly connected and reconnect it if necessary.
How to fix an EdgeStar IB120SS Ice Maker that doesn’t operate?
If your EdgeStar Ice Maker isn't operating, start by checking if it's properly plugged in. Also, inspect the breaker and reset it if necessary. If the issue persists, it might indicate a short circuit, so consider calling for service. Ensure that the power button is switched to the 'ON' position. Finally, if the ice storage bin is full or the wire shut-off arm is locked, remove some ice and lower the arm.
Why is my EdgeStar IB120SS not producing ice?
If your EdgeStar Ice Maker isn't producing ice, first ensure the wire shut-off arm is lowered. Additionally, verify that the water supply is turned on. If not, turn it on or contact a plumber.
What to do if my EdgeStar Ice Maker makes ice very slowly?
If your EdgeStar Ice Maker is making ice at a very slow rate, you can try the following: * Clean the condenser. * Ensure that nothing is blocking the airflow to the ice maker. * Check that the ambient temperature is in the proper range and that the unit isn't near a heat source. * Adjust the ice harvest control to a higher setting.
Why does my EdgeStar IB120SS accumulate frost so quickly?
If your EdgeStar Ice Maker accumulates frost and requires frequent defrosting, it's likely that the door is being left open or opened too often. Defrost the ice maker as needed, and make sure to keep the door closed as much as possible.
Why are the ice cubes from my EdgeStar IB120SS partially formed?
If the ice cubes from your EdgeStar Ice Maker are partially formed, the water supply pressure may be below 20 psig, or the water supply or filter may be restricted. Check the water supply pressure.
Covers crucial safety rules regarding electrical connections, grounding, and handling.
Details general safety precautions for operation, installation, and environment.
Welcome message and overview of the manual's purpose.
Lists items included with the ice maker, such as scoop and water line.
Specifies the necessary tools for installation and maintenance.
Instructions for safely removing the ice maker from its packaging.
Procedures for taking apart the door and hinge components.
Instructions for reversing the lower hinge mechanism.
Steps for reattaching the door after reversing the swing.
Step-by-step guide for attaching the water supply hose.
A list of checks to perform before starting the ice maker.
Instructions on how to turn on and start the ice production.
How to clean the outside surfaces of the ice maker.
Steps for cleaning the inside of the ice maker.
Details the aspects of the product protected by the warranty.
Lists exclusions and limitations to the warranty coverage.
Instructions on how to contact support and initiate warranty claims.
General| Brand | EdgeStar |
|---|---|
| Model | IB120SS |
| Reversible Door | No |
| Finish | Stainless Steel |
| Defrost Type | Manual |
| Drain Required | No |
| Power | 115 V/60 Hz |
| Ice Type | Crescent |
| Type | Ice Maker |
| Ice Production | 12 lbs per day |
| Ice Storage Capacity | 6 lbs |
| Certifications | UL |
To Next Page
