Why is the symbol on my EdgeStar Ice Maker LCD?
If the symbol is displayed on the LCD of your EdgeStar Ice Maker, it means there is too much ice in the basket. Remove some ice to resolve this.
What to do if the symbol is flashing on my EdgeStar IP250SS?
If the symbol is flashing on your EdgeStar Ice Maker, it indicates that there is not enough water in the reservoir. Stop the ice maker, fill it with water, and then restart it.
Why does my EdgeStar IP250SS have no power?
If your EdgeStar Ice Maker has no power, check these potential causes: * The ice maker might be unplugged: Plug it in. * The power switch might be off: Press the power button to turn it on; the Power Indicator light should illuminate. * The power outlet might not work: Try a different outlet. If it works on another circuit, consult a certified electrician to address the power issue. * There might be insufficient power: Connect the ice maker to a circuit that can provide enough power. Check the product label for power requirements.
Why is my EdgeStar IP250SS not making ice?
If your EdgeStar Ice Maker is going through the ice-making process but not producing ice, or the ice cubes are very thin and small, it might be because the room temperature or water is too hot. The unit is designed to operate in a room that is above 50°F and below 90°F. If the unit is in a warm room, move it to a cooler location.
How to fix water leaking from my EdgeStar IP250SS?
If water is leaking from your EdgeStar Ice Maker, ensure the drain plug is firmly attached at the bottom. If the plug is lost, contact EdgeStar to purchase a replacement.
What to do if the 'Add Water' light stays on in my EdgeStar Ice Maker?
If the 'Add Water' light is on even though your EdgeStar Ice Maker is full, the water may not have enough impurities. Try adding a pinch of salt to the water to add minerals, which will allow the unit to detect the water. Also, the water filter may be clogged, so use a brush with plastic bristles to clean the filter at the bottom of the water reservoir.
Why is my EdgeStar IP250SS Ice Maker making noise?
If your EdgeStar Ice Maker is making noise during operation, ensure the unit is level. Certain sounds are normal; refer to the “Normal Sounds” section of the owner’s manual.
Why does my EdgeStar IP250SS smell bad?
If your EdgeStar Ice Maker has a strange smell or the ice has an unappealing taste, the unit may need cleaning. Refer to the Cleaning and Maintenance section of this manual.
What does it mean when the symbol is on in my EdgeStar IP250SS?
Safety guidelines for electrical connections, grounding, and usage of the ice maker.
General safety precautions for operation, placement, and use by children or near flammables.
Step-by-step guide on how to start and use the portable ice maker.
Explains the functions of the control panel buttons and LCD display indicators.
To Next Page
General
