4
• The unit must sit on a secure and level surface. A mounting flange must NOT be used to
support the unit’s weight. It is important for the ice maker to be leveled in order to work
properly. If needed, you can adjust the height of the ice maker by revolving the rubber
leveling feet.
• If you are mounting the unit within cabinetry, make sure that the door has the desired
range of motion. All doors come with the hinge on the right side, but can be reversed if
desired.
• All electrical and water connections for the unit must be installed in accordance with all
state and local codes.
• A standard electrical supply, properly grounded in accordance with the National Electric
Code and local codes and ordinances is required.
Installation Clearance Requirements
• If the unit is to be built in, 1” or more must be allowed behind the unit for the water line
and plug clearance for proper operation.
• An additional ¼” must be left on both sides and the top of the unit.
• Fan-forced condenser cooling is used. This requires air circulation through the vents in
the lower front section of the unit. The grille must be unobstructed.
Caution:
1. There must be an unrestricted path for exhaust and fresh air intake. Recirculation
between fresh air intake and exhaust air must be prevented.
2. Any restriction of airflow or ventilation will disrupt the normal operation of the unit,
resulting in damage to components which voids the warranty.
3. Only connect the unit to a potable water supply.
To Next Page
Loading...
