General Safety
• To prevent back and other types of injuries, use at least two people to move and install the ice maker.
• Install the ice maker in a well ventilated area where the ambient temperature is above 50° F and
below 100° F.
• This unit is designed to be installed indoors, and protected from rain, sleet, snow, etc.
• This unit is not intended to be used by children.
• Children should be supervised to ensure that they do not play with this product.
• Never allow children to crawl inside the ice maker.
• Do not use this appliance near flammable gas or combustibles, such as gasoline, benzene, thinner,
etc.
• Do not place the unit near heat sources such as ovens and grills.
• Only use in an upright position on a flat, level surface and provide proper ventilation.
• Do not pinch or kink the water or power supply lines between the unit and cabinet.
• Unit installation must be in accordance with local plumbing code requirements.
• Make sure that the water supply lines and pipes are not pinched or kinked.
• Check for leaks after installation.
• Discard the first batch of ice cubes produced by the ice maker.
• Never turn the water supply tap off while the ice maker is running.
• If the unit has not been used for an extended period, thoroughly clean it before using it.
• Do not leave any cleaning solutions in the unit.
• Do not use solvent-based cleaning agents or abrasive solutions on the interior as they may transmit
taste to the ice cubes and damage the interior.
• Only connect a potable water supply.
• This appliance is not intended for use by persons, including children, with reduced physical, sensory,
or mental capabilities, unless they have been given supervision or instruction concerning the use of
the appliance by the person(s) responsible for their safety.
To Next Page
Loading...
Need help?
General
