EdgeStar IP210SS - Using Your Ice Maker

1. Select thesizeoftheicecubebypressingthe “Select”button.Iftheroomtemperatureis
lowerthan60°F,itisbesttoselectthesmallormediumicesize,otherwisetheicecub es
mightsticktogether.
2. Openthecover, removetheicebasketandpourwaterintotank.
Keepwaterlevelbelowthelevelmark.
3. Press“Power”onthecontrolpaneltobegi ntheicemakingcycle.
4. The ice making cycle las ts 6 to 15 minutes, depending on the size of the ice cubes
selected.
5. Whilethe ice makerison,verifythewaterlevelperiodically.Ifthewater levelistoolow,
theicemakerwillstopautomatically, andthe“Water”indicatorwillturnon.
Pressthe“Power”button,filltheunitwithwater,andpress“Power”again.
Allowtherefrige rantinsidethecompressoratleast3minutestosettlebeforerestarting.
6. Theicemakerautomaticallystopsworkingwhentheicebasketisfull.
7. Change the waterinthewaterreservoirevery24 hoursto ensurea reasonable hygiene
level.
Iftheicemaker willno tbeusedforanextendedpe riodoftime,youshoulddrainthewater
fromthereservoirandwipeouttheins ideoftheunit.
5